Yaskawa MP920 User's Manual Design - Manual (Page 199)

5 Modules
5.1.2 PS-01 Module
5-4
„ Application Precautions
Observe the following precautions when using the PS-01 Power Supply Module.
• One Power Supply Module is required for every Mounting Base.
• More than one Power Supply Module cannot be mounted to one Mounting Base. The
Power Supply Module must be mounted to the dedicated slot on the left side of the
Mounting Base.
• The supply of direct current from the Power Supply Module is restricted depending on
the Mounting Base to which the Power Supply Module is mounted. Power is not sup-
plied to Modules that are mounted to a a different Mounting Base.
• The output current capacity of the PS-01 Power Supply Module is 10 A.
• The following table shows the input current for a maximum load (maximum output cur-
rent) of 10 A when using an input voltage of 100 or 200 VAC.
Maximum Load Input Voltage (VAC) Input Current (A)
10 A 100 1.2
200 0.6
Installation position of
Power Supply Module Other Modules can be installed in
any of these positions.