Yaskawa MP920 User's Manual Design - Manual (Page 335)

6.2 System Startup Procedure
6-5
6
6.2 System Startup Procedure
This section explains the procedure when a Test System is used for positioning control. Refer to
the relevant reference manuals for the operation required for each procedure. Details of the
machine system design have been omitted here.
6.2.1 Installing the Modules
Install the Power Supply, CPU, Input, Output, and other Modules on the Mounting Base.
„ Installation Position of Each Module
The installation position of the Power Supply Module is fixed, but other Modules can be
installed in any other position.
„ Procedure for Installing Modules
The large and small protrusions on the back of each Module fit into the corresponding holes
in the Mounting Base.
Installation position of Power
Supply Module Other Modules can be installed
in any of these positions.
Protrusion
(small)
Protrusion
(large)