Yaskawa MP920 User's Manual Design - Manual (Page 294)

5.5 Motion Modules
5-99
5
„ LED Indicator 2
The TRX indicator displays the communications status of the SVB-01 Module.
„ MECHATROLINK Connector
„ Connector Specifications
The following table shows the specifications of the connector used to connect the SVB-01
Module.
„ CN1 Connections
The connector ports on the right and left sides of the CN1 are the same. Use either the left or
rigth port.
Insert an USB terminator JEPMC-W6020 in the unused port.
The SVB-01 Module has MECHATROLINK port for one channel. Two ports are provided on the CN1
MECHATROLINK connector, however, these two ports are the same as shown in the figure above.
Indicator Name Indicator Color Meaning When Indicator Is Lit
TRX Green Transmission enabled
The MECHATROLINK connector is used to connect an SVB-01 Mod-
ule and SERVOPACK and IO350 unit using MECHATROLINK cables
(JEPMC-W6000-A3 or JEPMC-W6000-01).
TRX
Name Connector
Name
Number
of Pins
Connector Cable
On Module On Cable Manufacturer
MECHATR-
OLINK
Connector CN1 4 DUSB-APA42-
T11 USB-USB
connector boby:
DUSB-APA41-B1-C50 DDK JEPMC-W6000-A3
USB-Loose wires
connector boby:
DUSB-APA41-B1-C50 DDK JEPMC-W6010-01
JEPMC-W6010-03
JEPMC-W6010-05
USB terminator
connector boby:
DUSB-APA41-B1-C50 DDK JEPMC-W6020
Left side on CN1 Right side on CN1
CN1 1
2
3
4
1
2
3
4
NC
SH
DATA
/DATA
NC
SH
DATA
/DATA
IMPORTANT