Yaskawa MP920 User's Manual Design - Manual (Page 205)

5 Modules
5.2.1 CPU-01 Module
5-10
„ DIP Switch
The DIP switch consists of eight pins. The pins are numbered 1 to 8, as shown in the dia-
gram with Table 5.2.
Each pin is ON when it is moved to the left.
The pins other than L.RST and M.RST are valid only when the power turns ON and at the
startup after resetting.
Turn OFF the power and then ON again when changing the mode.
The function of each pin is described below.
Table 5.2 DIP Switch Functions
Pin Name Setting Function Default
1 L. RESET ON Local reset OFF
OFF Online
2 RUN ON User program executed. ON
OFF User program stopped.
3 INITIAL ON Pin 4 ON: Memory cleared. OFF
OFF Pin 4 ON: Setting disabled.
4 TEST ON Terminal mode/initialization mode OFF
OFF Online
5 PP
Defaults
ON Defaults for port 1 only OFF
OFF Use memory settings.
6 MULTI ON Multiple CPU in configuration OFF
OFF Single CPU in configuration
7 FLASH ON Program copied from flash memory to RAM. OFF
OFF Program not copied from flash memory to
RAM.
8 M.RST ON Master reset OFF
OFF Online
SW1
L.RST
RUN
INIT
TEST
MULTI
FLASH
M.RST
ON OFF
ON 123
456
7
8