Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 96)

4–16

RSView32 User’s Guide
Data Type
The data types are:
Data type Description Range
Default Depends on the data
source and node type:
If Device is the data
source, for direct driver
nodes RSView32 matches
the data format specified
by the address, for
example, N7:0=Integer,
F8:0=Floating Point.
Do not use Default for
OPC or DDE nodes, as
this might produce
unexpected results.
If Memory is the data
source, Default is Floating
Point.
See below.
Unsigned Integer Unsigned 16–bit integer 0 to 65,535
Integer Signed 16–bit integer -32,768 to 32,767
Long Integer Signed 32–bit integer -2,147,483,648 to
- 2,147,483,647
Floating Point Single–precision (32–bit)
floating point -3.402823E +38 to -
1.175494E -38 ,
0,
1.175494E
-38 to
3.402823E +38
Byte Unsigned 8–bit integer 0 to 255
3–Digit BCD 3–digit binary–coded
decimal 0 to 999