Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 675)

RSView32 commands

A–55
Special keys can be in upper and/or lower case letters. You can type
any of the following to represent the special keys on the keyboard:
Set
[&]Set [/V]
Writes a value to a tag.
[&] Forces the command to be executed asynchronously,
which makes the command faster.
[/V] Performs a read immediately after the write to verify
that the value was altered in the programmable
controller or server.
This parameter is useful if the network is in poor
condition or susceptible to noise interference.
If the verification fails, the error message is logged to
the activity log, activity bar, or printer using the Tag
Write category. Specify where to send Tag Write
errors using the Categories tab of the Activity Log
Setup editor.
<tag_name> The name of a tag.
Backspace, BkSp, BS Insert
End Left
Enter PgDn
Escape, Esc PgUp
Delete, Del PrtSc
Down Right
F1 to F12 Tab
Home Up
If a node has been disabled, the Set command changes the value in
the value table but not in the programmable controller. IMPORTANT