Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 54)

2–14

RSView32 User’s Guide
Before you can configure a device node, you must set up
communication channels. For details, see “Configuring channels” on
page 2-7.
To create a node:
1. In the Project Manager, open the System folder.
2. Open the Node editor by doing one of the following:
double–click the Node icon
right–click the Node icon and then click Show
3. Fill in the following information for each node:
Data Source
Select Direct Driver.
For details about the OPC Server and DDE Server data sources,
see Chapter 3, Setting up OPC and DDE communications.
Name
Type a name of your choice up to 40 characters long. This name
represents the programmable controller. The name can have upper