Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 543)

Setting up navigation

15–3
Commands for moving among displays
To open, close, and switch between displays, use these commands: 1.
RSView32
Command
Function
Display Opens the specified graphic display.
If a display is already open and the display allows
multiple running copies (specified in the Display
Settings dialog box in the Graphic Display editor),
this command will open another display and make it
active. If the display is already open but does not
allow multiple running copies, this command simply
makes the display active.
If a display of type Replace overlaps any other
display(s) when it opens, the display(s) it overlaps will
be closed.
Displays of type Overlay open on top of any other
open displays without closing them.
Displays of type On Top will remain on top of any
other open graphic displays.
Abort Use this command only for displays of type Overlay
or On Top. The Abort command closes the active
display or a specified display.
PullForward Pulls forward the specified display. If the specified
graphic display is of the Replace or Overlay type,
PullForward gives the specified display focus and
positions it behind any On Top display that is open.
PushBack Pushes the specified display behind other displays. If
the specified graphic display is of the On Top type,
PushBack positions the display behind any other
open On Top displays, and in front of any open
displays of the Replace or Overlay type.