Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 46)

2–6

RSView32 User’s Guide
Using the drivers
To configure and use the RSLinx drivers with a direct connection, the
drivers must be installed on the same computer as RSView32. Once
the drivers are configured, RSView32 automatically starts the driver
software whenever communication with a programmable controller is
required—for example, to test run a graphic display or to run a
project.
Selecting a driver in RSView32
To select a driver in RSView32, the driver must first be configured in
RSLinx. All configured drivers appear in the RSView32 Channel
editor Primary or Secondary Communication Driver fields.
If the Channel editor is open when you add a driver in RSLinx, close
the Driver list by clicking another part of the editor, and then re–open
the list.
You must use the version of RSLinx that came with your RSView32
software. This version has been tested for compatibility with
RSView32. Other versions may not function correctly.
IMPORTANT