Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 616)

18–12

RSView32 User’s Guide
4. Select a component.
5. In the New Path For Component field, specify a new path.
6. Click OK.
Changing the database path
In the Database Paths tab, you can change the database that will be the
data source for the project.
1. Click the Browse button beside the Path to Database field.
2. Select the new data source and then click Open.
3. Click OK.
4. Close and re–open the project to complete the operation.
Specifying time, date, and number formats
If the target computer is configured for a different locale than the
development computer, and the new locale uses different time, date,
or number formats, follow these steps. Once the project is loaded on
the computer on which it will run, use the Windows Control Panel to
specify time, date, and number formats. These formats apply to the
runtime components of the project only. You can also change these
formats after the project is running, but you must close and restart the
project for the changes to take effect.
1. Click the Start button on the Windows task bar, point to Settings,
and then click Control Panel.
The Control Panel window opens.
2. Double-click Regional Settings or Regional Options.
Specify the new
path here.