Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 673)

RSView32 commands

A–53
RTDataWrite
Disable
RTDataWriteDisable [/Quiet] [/NetDDE]
Disables writes by external Windows applications running OPC or
DDE, so these applications cannot change tag values in RSView32.
The RSView32 OPC or DDE server is also known as the real-time
data server. If the RSView32 real-time data server is not running—
that is, if the RTDataServerOn command has not been run—
RTWriteDisable also starts the RSView32 real-time data server.
[/Quiet] Makes RSView32 use the current Remote Users
accessibility setting in the Windows Registry. Without
this parameter or if the setting is not configured
correctly, RSView32 displays a dialog box that allows
you to specify the setting when you issue the
command.
[/NetDDE] Enables RSView32 as a NetDDE server to remote
DDE clients. If the real-time data server is already
running, this parameter is ignored.
By default, writes are disabled. Therefore, the RTDataWriteDisable
command is required only after the RTDataWriteEnable command
has been used.
RTDataWrite
Enable
RTDataWriteEnable [/Quiet] [/NetDDE]
Enables writes by external Windows applications using OPC or DDE,
so these applications can change tag values in RSView32.
The RSView32 OPC or DDE server is also known as the real-time
data server. If the RSView32 real-time data server is not running—
that is, if the RTDataServerOn command has not been run—
RTDataWriteEnable also starts the RSView32 real-time data server.
[/Quiet] Makes RSView32 use the current Remote Users
accessibility setting in the Windows Registry. Without
this parameter or if the setting is not configured
correctly, RSView32 displays a dialog box that allows