Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 159)

Configuring alarms

6–33
1. If required, using the ODBC Administrator, set up an ODBC data
source name. For an example, see page 7-16.
2. Double–click Events in the RSView32 Logic and Control folder.
3. In the Expression box, type:
time(“01:00”)
. This expression runs
the command or macro you type in the Action box at 1:00 am
every day.
4. If the ODBC data source is called RSView32AlarmLog, the target
table name is AlarmTable, the user name is Derek, and the
password is golf, in the Action box, type:
AlarmLogSendToODBC RSView32AlarmLog AlarmTable /
UDerek /Pgolf
5. Click Accept to save the event.
6. Click Close to save the event file.
7. At the command line, type
EventOn <filename>
where <filename>
is the name of the event file you saved.
For information about the format of the alarm log ODBC tables, see
page 16-11.
Configuring alarm severity
For each alarm severity and alarm incident, you can configure logging
destinations. You can also specify how you want alarms of a particular
severity to be annunciated.
8.