Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 669)

RSView32 commands

A–49
PushBack PushBack
Moves the specified graphic display behind all other windows. If the
specified graphic display is of the On Top type, PushBack positions
the display behind any other open On Top displays, and in front of
any open displays of the Replace or Overlay type.
<file> The name of an open graphic display file without a
file extension.
If the specified display is of the On Top type, and if no other On Top
displays are open, nothing happens when you issue this command.
Quit Quit [/R]
Quits RSView32, stopping all project components, and returns to
Windows.
[/R] Restarts the computer.
Ramp Ramp [/V]
Increases or decreases a tag value by a particular value or by another
tag’s value.
Use this command only with analog tags.
[/V] Performs a read immediately after the write to verify
that the value was altered in the programmable
controller or server.
This parameter is useful if the network is in poor
condition or susceptible to noise interference.
If the verification fails, the error message is logged to
the activity log, activity bar, or printer using the Tag
Write category. Specify where to send Tag Write
errors using the Categories tab of the Activity Log
Setup editor.
<tag_name> The name of an analog tag.