Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 562)

15–22

RSView32 User’s Guide
Running global key files
Use the RSView32 Key command to run global key files. Type this
command in a macro or anywhere else you can use an RSView32
command.
To start running a global key file, do one of the following:
In the Startup editor, select the Global Key File check box and
specify the file you want to run
On the command line or in a macro, type:
Key <file>
<file> the name of the global key file without an
extension
To stop running a global key file:
On the command line or in a macro, type:
Key /R
/R removes all key definitions
For a complete list of RSView32 commands and command syntax, see
Appendix A, RSView32 commands, or see Help.
You cannot run more than one global key file at a time. If you try to
run more than one file, the files are not merged. Instead, the second
file overrides the first file. IMPORTANT