Allied Telesis AT-S102 - Manual (Page 88)

Chapter 4: Starting a Management Session
88
To set the date and time:
1. From the Main Menu, select Configuration.
2. From the Configuration Menu, select System Configuration.
3. From the System Configuration Menu, select System Parameters
Configuration.
4. From the System Parameters Configuration menu, select System
Clock Configurations.
5. To set the date and time manually, do the following:
a. In the System Clock Menu, select System Date (mm/dd/yy) and
enter a new date in the format “mm/dd/yy” format. For example,
April 5, 2008 would be 4/5/08.
b. Select System Time (hh:mm:ss) and enter a new time in 24-hour,
“hh:mm:ss” format. The seconds are optional. For example, 8:15
am would be 08:15.
6. To configure the NTP client, do the following:
a. Select NTP Server and enter the IP address of the NTP server.
b. Select the NTP UTC Offset field and enter the time difference, in
hours, between the Universal Time Coordinated (UTC) and your
local time. The range is between -12 and +12 hours. The default is
0 hours.
c. To enable the client, select Enable NTP.
7. Return to the Main Menu.
Naming the
Management
Card
The management card will be easier to identify if you assign it a name.
The name is displayed at the top of the menus in the management
software. To assign a name to the management card:
1. From the Main Menu, select Configuration.
2. From the Configuration Menu, select System Configuration.
3. From the System Configuration Menu, select System Parameters
Configuration.
4. Select System Name and enter a new name of up to 39 characters for
the card. Spaces and special characters are permitted.
5. Return to the Main Menu. The new name does not appear in the
menus until you return to the Main Menu.