Allied Telesis AT-S102 - Manual (Page 46)

Chapter 2: AT-CM and AT-CV Media Converter Line Cards
46
Management Software
The line cards use the following management programs:
ˆ AT-CM2 and AT-CM70S Line Cards: AT-S73 Management Software
ˆ AT-CM3 Line Cards: AT-S102 Management Software
The devices come with the programs preinstalled. The default settings for
the parameters can be found in Appendix A, “Default Settings for the
Management Card and the Line Cards” on page 337.
Allied Telesis may periodically make available on our web site new
versions of the management programs. Installing the new programs
requires the AT-CV5M02 Management Card. For instructions, refer to
Chapter 11, ”Uploading and Downloading Files” on page 315.
The AT-CV Line Cards do not have management software
Maximum Frame Sizes
The line cards have the following maximum frame sizes:
ˆ AT-CM2 and AT-CM70S Line Cards: 1522 bytes
ˆ AT-CM3 Line Cards: 10240 bytes
ˆ AT-CV Line Cards: 9000 bytes
With one exception, the maximum frame sizes are not adjustable on the
line cards. The sole exception is the maximum frame size for the
AT-CM2K0S Line Card, which can be increased to 1632 bytes. For
instructions, refer to “Configuring the Maximum Frame Size on the
AT-CM2K0S Line Card” on page 182.
Low Power Mode
The AT-CM3 Line Cards have a low power mode that lets you conserve
power by turning off the LEDs when you are not monitoring them. The
feature can be controlled either through the AT-CV5M02 Management
Card or with the recessed ECO Friendly button on the front panels of the
line cards.
Activating or deactivating the low power mode does not interfere with the
network operations of the cards. Additionally, this mode does not control
the RDY LEDs on the line cards.
The low power mode is not available on the AT-CM2, AT-CM70S and
AT-CV Line Cards.