Allied Telesis AT-S102 - Manual (Page 37)

Converteon Management Software User’s Guide
37
Figure 1. Updating the Master Configuration File on a Standby Card
(The incrementing number at the bottom of the screen is the ID number of
the parameter setting the active card is transmitting to the standby card.
All parameter settings have unique ID numbers. The number can be
ignored.)
After the management card has sent the entire master configuration file, it
displays “Succeeded.” To resume managing the chassis, press any key.
The status messages are somewhat different if you install a second
management card while viewing the Module Configuration and Status
menu or the Remote Module Configuration and Status menu; but their
meanings are the same.
SNMPv3
Configuration
Files
If you plan to manage the chassis with SNMPv3, you should know that the
settings to the SNMPv3 tables are not stored in the master configuration
file, but rather in an auxiliary file called the SNMPv3 configuration file. Just
like the master configuration files, there are two of them, one in DRAM,
which is updated automatically by the management card whenever you
change a value in the SNMPv3 tables, and the other in flash memory,
which is updated in response to the save command.
The management software does not have different save commands for
updating the master configuration file and the SNMPv3 configuration file to
flash memory for permanent storage. Instead, the same command, Save
System Configuration, stores both files. When you enter that command,
the management card stores both files, the master configuration file and
the SNMPv3 configuration file, from DRAM to flash memory. For more
information about this command, refer to “Saving the Configuration of the
AT-CV5M02 Management Card” on page 78.
===========================================================
Active Management Card (AT-CV5M02) founded in Slot [ 2]
Standby Management Card (AT-CV5M02) founded in Slot [ 5]
===========================================================
-> Waiting for Standby to be Ready ... Please Wait ....... Not Ready
-> Waiting for Standby to be Ready ... Please Wait ....... Not Ready
-> Waiting for Standby to be Ready ... Please Wait ....... Ready
<- Copy Configuration to Standby .... Please Wait ..078.. Succeeded