Allied Telesis AT-S102 - Manual (Page 302)

Chapter 10: Configuring SNMPv3
302
Group Name a Group Name that you configured in the SNMPv3 Access
Table. Refer to “Configuring the SNMPv3 Access Table” on
page 296.
There are four default values for this field:
ˆ defaultV1GroupReadOnly
ˆ defaultV1GroupReadWrite
ˆ defaultV2cGroupReadOnly
ˆ defaultV2cGroupReadWrite
These values are reserved for SNMPv1 and SNMPv2c
implementations.
Storage Type The possible values are:
V-Volatile
This selection blocks the management card from saving the
entry in the master configuration file.
N-NonVolatile
This selection allows the management card to save the entry in
the master configuration file when a save command is issued.
Allied Telesis recommends this storage type.
Row Status This parameter appears only when you display the SNMPv3
Group Table. The Active value indicates the entry takes effect
immediately.
Table 36. SNMPv3 Group Table Parameters
Parameter Description