Allied Telesis AT-S102 - Manual (Page 162)

Chapter 6: Configuring the Media Converter Line Cards
162
AC (Continued) ˆ Y for Yes - The auto-copy feature is activated on the slot. The
configuration settings for the AT-CM Line Card in the slot are
provided by the management card from the master configuration
file.
The AT-CM70S Line Card and the AT-CV Line Cards do not support
the auto-copy feature.
VER This column displays the version numbers of the management
software programs on the AT-CV5M02 Management Card and the
AT-CM Line Cards. This field may be blank for AT-CM Line Cards
that have a different version of AT-S73 Management Software than
the version of the management software on the management card.
This field will also be blank for AT-CV Line Cards because they do
not have management software.
FIBER PORT or COPPER PORT
ST This column displays the states of the ports. The possible states
are:
ˆ * - The port has establish a link to a network device.
ˆ o - The port has not establish a link to a network device.
SP This column displays the speeds of the ports. The possible speeds
are:
ˆ 10 - 10 Mbps
ˆ 100 - 100 Mbps
ˆ 1G - 1 Gbps
FC This column displays the status of flow control on the ports of the
AT-CM Line Cards. The possible states are:
ˆ Y - Flow control is enabled on the port.
ˆ N - Flow control is disabled on the port.
IngRL This column displays the settings of the ingress rate limiting filters
on the ports on the AT-CM Line Cards. The value “0” means rate
limiting has not been set on the port. This is the default setting. For
instructions on setting this parameter, refer to “Configuring the Port
Parameters on the AT-CM Line Cards” on page 169. This feature is
not supported on the AT-CV Line Cards.
Table 19. Module Status and Configuration Menu
Column Description