beautypg.com

Configuring the 10/100base-tx port, Menus – Allied Telesis AT-S102 User Manual

Page 133

background image

Converteon Management Software User’s Guide

133

Configuring the 10/100Base-TX Port

The procedures in this section explain how to set the speed and duplex
mode on the 10/100Base-TX port on the AT-CV5M02 Management Card.
The management card uses this port to communicate with your network
for those management functions that require it, such as sending event
messages to a syslog server or uploading or downloading files to a TFTP
server. For background information, refer to the “10/100Base-TX Port” on
page 23.

Note

The port cannot be disabled and the port’s wiring configuration of
MDI cannot be changed.

Menus

To configure the settings of the 10/100Base-TX port on the AT-CV5M02
Management Card from the menus:

1. From the Main Menu, select Module Status and Configuration. For

the description and an example of the Module Status and
Configuration window, refer to “Displaying the Status of the Line
Cards” on page 158.

2. Select the AT-CV5M02 Management Card. If the chassis has two

management cards, select the active card. This displays the Module
Configuration Menu in Figure 35 on page 120. The columns in the
Module Configuration Menu are described in Table 15.

Table 15. Module Configuration Menu for a Management Card

Column

Description

Port

The port type is 10/100Base-TX.

Link

The status of the link on the port. Possible values
are:

ˆ

Online: The port has established a link to a
network device.

ˆ

Offline: The port is not connected to a network
device or has not established a link to a device.

Speed

The operating speed of the port. Possible values are
10M or 100M.

Mode

The duplex mode of the port.

ˆ

Full - The port is operating in full-duplex mode.

ˆ

Half - The port is operating in half-duplex mode.

This manual is related to the following products: