Allied Telesis AT-S102 - Manual (Page 120)

Chapter 5: Configuring the AT-CV5M02 Management Card
120
2. Select the AT-CV5M02 Management Card. If the chassis has two
management cards, select the active card. This displays the Module
Configuration Menu in Figure 35.
Figure 35. Module Configuration Menu (Management Card)
3. Select Reset Management and Restart System Software.
4. At the confirmation prompt, select Yes to reset the card or No to
cancel the procedure.
5. To resume managing the chassis, wait approximately one minute for
the management card to initialize its management software and then
start a new management session.
Web Browser
To reset the AT-CV5M02 Management Card from the web browser
windows:
1. Select Module Status and Configuration from the menu bar.
2. From the Chassis View, click the 10/100Base-TX port on the
AT-CV5M02 Management Card. Alternatively, select the Menu View
and click the model name of the management card.
Module Configuration Menu
Module 1
Module: AT-CV5M02
Port Link Speed Mode
A(100BaseTx) Online 100M Full
Module name
Reset Management and Restart System Software
Return Management Card Port Configuration to Default
Return to Module Status and Configuration Menu...