Restoring the default settings – Allied Telesis AT-S102 User Manual
Page 225
Converteon Management Software User’s Guide
225
minute. Afterwards, the cards use the settings in their configuration
files to configure their operating parameters.
To configure the operating mode from the menus:
1. From the Remote Module Configuration Menu, select Line Card
Configuration.
2. If you want to use the DIP switches on the card itself to set the card’s
operating mode, select Line Card DIP Switch Mode, and skip to step
4. This is the default setting. If you prefer to set the card’s operating
mode using the management software, select Line Card
Management Mode.
3. In the Configure Operating Mode Via Management Card menu, select
the desired mode for the card.
The line card resets and begins to initialize its management software.
4. To continue managing the line card, return to the Main Menu and wait
one to two minutes for the card to initialize its management software
and, if you selected an OAM mode, to negotiate the OAM settings with
its local counterpart. Then select the card again from the Remote
Module Status and Configuration menu.
Restoring the
Default Settings
This procedure is used to restore a remote line card to its default settings.
The default settings for the line cards can be found in Chapter A, ”Default
Settings for the Management Card and the Line Cards” on page 337.
Review the following information before performing this procedure:
If the default operating mode of a line card is not an OAM mode, the
line card will not support remote peer management after it is returned
to its default values.
Caution
If the card’s current operating mode is not the default mode, the card
will reset, possibly resulting in the loss of some network traffic. The
line card will immediately resume forwarding traffic, but it will be
unresponsive to management commands for one minute while it
initializes its management software.
To return the parameter settings on a remote line card to their default
values from the menus:
1. From the Remote Module Configuration Menu, select Configure
Operating Mode.