Configuring the snmpv3 access table, Figure 129. configure snmpv3 access table menu – Allied Telesis AT-S102 User Manual
Page 296
Chapter 10: Configuring SNMPv3
296
Configuring the SNMPv3 Access Table
This section describes the parameters for SNMPv3 Access Table entries.
The SNMPv3 Access Table is used to configure security groups. Each
user must belong to a security group. After you have configured a security
group, use the Group Table to assign users to security groups.
The parameters are:
Group Name
Security Model
Security Level
Read View Name
Write View Name
Notify View Name
Storage Type
Before adding entries to the Access Table, you should configure entries in
the View Table. These values are used to configure the Read, Write, and
Notify View parameters. Refer to “Configuring the SNMPv3 View Table”
on page 293.
To access the SNMPv3 Access Table from the menus.
From the Main Menu, select Configuration -> System Configuration
-> System Parameters Configuration - > SNMPv3 Configurations
-> Configure SNMPv3 Access Table. The Configure SNMPv3
Access Table menu is shown in Figure 128.
Figure 128. Configure SNMPv3 Access Table Menu
Configure SNMPv3 Access Table
Converteon
Create SNMPv3 Table Entry
Delete SNMPv3 Table Entry
Modify SNMPv3 Table Entry
Display SNMPv3 Table Entry
Return to SNMPv3 Configurations ...