Allied Telesis AT-S102 - Manual (Page 244)

Chapter 8: Configuring the T1/E1 Ports on the AT-CM70S Media Converter Line Card
244
3. Using the management card, configure the settings of the two
AT-CM70S Line Cards, including the settings for the T1/E1 ports, as
required by your network.
4. For the AT-CM70S Line Card to be deployed at the remote site,
change its UART setting to UART local console mode after configuring
its T1/E1 ports. This will make it possible for you to adjust the settings
of the T1/E1 ports from the Console port when the line card is installed
at the remote site.
How to set the UART setting on the AT-CM70S Line Card is explained in
the following procedure. The procedure requires the AT-CV5M02
Management Card. The UART setting cannot be set through the Console
port on the card.
Caution
This procedure may be disruptive to network operations. The
AT-CM70S Line Card resets and initializes its management software
when the UART setting is changed. Some network traffic may be
lost.
To set the UART setting on the AT-CM70S Line Card from the menus:
1. From the Main Menu, select Module Status and Configuration. The
Module Status and Configuration Menu is shown in Figure 58 on page
158.
2. Select the AT-CM70S Line Card you want to configure. The Module
Configuration Menu is shown in Figure 63 on page 169.
3. From the Module Configuration Menu, select 3: TDM LIU (T1/E1)
Configuration to display the TDM Management Menu shown in
Figure 99.
Figure 99. TDM Management Menu
The TDM Port Configurations selection appears in the menu only
when the line card’s UART setting is set to UART backplane mode.
TDM Management Menu
Module 15, Port C
TDM Port Configurations
UART Configurations
Return to Module Configuration Menu ...