Allied Telesis AT-S102 - Manual (Page 223)

Converteon Management Software User’s Guide
223
Your changes to the settings on a remote line card are automatically
saved in the card’s configuration file in flash memory and are retained
even if the remote chassis is powered off or the card is removed from
the unit. For further information, refer to “Configuration Files” on
page 32. For instructions on how to save the changes to the master
configuration file on the AT-CV5M02 Management Card, refer to
“Saving the Parameter Settings” on page 227.
3. When you finish configuring the remote line card, return to the Remote
Module Configuration Menu and select Return to Remote Module
Status and Configuration to display the Remote Module Status and
Configuration menu again.
Naming a Remote
Line Card
To assign a name to a remote line card:
1. From the Remote Module Configuration Menu, select the Module
Name field.
2. Enter a name of up to eight alphanumeric characters.
Displaying the
Parameter
Settings of a
Remote Line
Card
To view the current settings of a remote card:
1. From the Remote Module Configuration Menu, select Line Card
Configuration.
2. From the Line Card Configuration menu, select Display Current
Configuration. An example of the window is shown in Figure 61 on
page 166. The port parameters are described in Table 21 on page 171
and the OAM parameters in Table 31 on page 255.
Configuring
Remote Ports
To configure the parameter settings of a port on a remote line card:
1. From the Remote Module Configuration Menu, select the port you
want to configure. You can configure only one port at a time.
2. From the Port Management Menu, select Port Configurations to
display the Remote Port Configuration Menu. This menu contains the
current settings of the port.
3. Configure the parameters, as necessary. Refer to Table 21 on
page 171 for the parameter descriptions.