At-cm3 media converter line cards – Allied Telesis AT-S102 User Manual
Page 342
Appendix A: Default Settings for the Management Card and the Line Cards
342
AT-CM3 Media Converter Line Cards
This table lists the factory default settings for the AT-S102 Management
Software on the AT-CM3 Media Converter Line Cards.
Table 47. Default Settings for the AT-CM3 Line Cards and the AT-S102
Management Software
Parameter
Default Setting
Default Operating Mode
Link Test and OAM Visible
Name
None
Maximum Frame Size
10240 bytes
Low Power Mode
Disabled
Port A (Fiber Optic Port)
State
Enabled
Flow Control
Enabled
Ingress Rate Limit
No Limit
Egress Rate Limit
No Limit
Port B (Twisted Pair Port)
State
Enabled
Flow Control
Enabled
Speed and Duplex Mode
Auto-Negotiation
Ingress Rate Limit
No Limit
Egress Rate Limit
No Limit
OAM
Admin State
Enabled
Mode
Passive
Maximum OAMPDU Size
1518 octets
Unidirectional Support
Yes
Loopback Support
Yes
Event Support
No
Variable Retrieval Support
Yes