Allied Telesis AT-S102 - Manual (Page 221)

Converteon Management Software User’s Guide
221
FC This column displays the status of flow control on the ports of the
remote line cards. The possible states are:
ˆ Y - Flow control is enabled on the port.
ˆ N - Flow control is disabled on the port.
IngRL This column displays the settings of the ingress rate limiting filters
on the ports on the remote line cards. The value “0” means there is
no rate limiting on the port. This is the default setting.
EgrRL This column displays the settings of the egress rate limiting filters on
the ports on the line cards. The value “0” means there is no rate
limiting on the port. This is the default setting.
OAM This column displays the status of the OAM clients on Port A, the
fiber optic ports, on the remote line cards. The following OAM client
information is displayed:
A This alternates between “*” and “o” when a remote fiber optic
port is transmitting OAMPDUs. Otherwise, it remains “o”.
B This alternates between “*” and “o” when a remote fiber optic
port is receiving OAMPDUs. Otherwise, it remains “o”.
C This displays the operational state of the OAM client on the fiber
optic port on a remote line card. The possible states are:
* - Operational
A - Active Send Local
D - Disabled
L - Active Send Local
M - Peer Remote Reject
P or W - Passive Wait
R - Peer Local Reject
1 - Active Send Remote 1
2 - Active Send Remote 2
Table 26. Remote Module Status and Configuration Menu
Column Description
00*
C
B
A