Allied Telesis AT-S102 - Manual (Page 294)

Chapter 10: Configuring SNMPv3
294
Figure 127. SNMPv3 View Table Tab
A knowledge of the OID table is required to create view entities. You can
be very specific about the view a user can or cannot access—down to a
column or row of the table. The AT-S99 Management Software program of
the AT-CV5M02 Management Card supports the Internet subtree of the
OID table.
The parameters for SNMPv3 View Table entries are defined in Table 34.
Table 34. SNMPv3 View Table Parameters
Parameter Description
View Name A descriptive name for this view of up to 32 alphanumeric
characters.
Note
The “defaultViewAll” value is the default entry for the
SNMPv1 and SNMPv2c configuration. You cannot use
this default value for an SNMPv3 View Table entry.
View Subtree The subtree that this view will or will not be permitted to
display. You can enter either a numeric value in hex format or
the equivalent text name. For example, the OID hex format for
TCP/IP is:
1.3.6.1.2.1.6
The text format is for TCP/IP is:
tcp