Allied Telesis AT-S102 - Manual (Page 307)

Converteon Management Software User’s Guide
307
To access the Configure SNMPv3 Target Address Table from the web
browser windows:
ˆ :Click the Configuration button in the menu bar and then select the
SNMPv3 tab and the Target Address Table tab. The Target Address
Table tab is shown in Figure 135.
Figure 135. SNMPv3 Target Address Table Tab
Table 38. SNMPv3 Target Address Table Parameters
Parameter Description
Target Address Name The name of the SNMP manager, or host, that manages the
SNMP activity on your switch. The name can be up to 32
alphanumeric characters.
IP Address (TAddress) The IP address of the host. The IP address is entered in this
format:
XXX.XXX.XXX.XXX
UDP Port#: The UDP port. The range is 0 to 65,535. The default port is
162.
Timeout (10mS)] The timeout value in milliseconds. When an Inform message is
generated, a response from the device is required. The timeout
value determines how long SNMPv3 considers the Inform
message as an active message. This parameter applies to
Inform messages only. The range is from 0 to 2,147,483,647
milliseconds. The default value is 1500 milliseconds.
Retries The number of times the switch retrIes, or resends, an Inform
message. When an Inform message is generated, a response
from the switch is required. This parameter determines how
many times the switch resends an Inform message. The
Retries parameter applies to Inform messages only. The range
is 0 to 255 retries. The default is 3 retries.