Allied Telesis AT-S102 - Manual (Page 306)

Chapter 10: Configuring SNMPv3
306
Configuring the SNMPv3 Target Address Table
The SNMPv3 Target Address Table is used to designate the IP addresses
of hosts to receive notifications. The SNMPv3 Target Address Table is
linked internally to the SNMPv3 Notify Table through the Tag List
parameter. The entries in the SNMPv3 Notify Table receive the host IP
addresses from the entries in the SNMPv3 Target Address Table.
The parameters of the entries in the SNMPv3 Target Address Table are:
ˆ Target Address Name
ˆ Target IP Address
ˆ UDP Port
ˆ Timeout Value
ˆ Number of Retries
ˆ Tag List
ˆ Target Parameters
ˆ Storage Type
The parameters are defined in Table 38 on page 307.
To access the Configure SNMPv3 Target Address Table from the menus:
ˆ From the Main Menu, select Configuration -> System Configuration
-> System Parameters Configuration - > SNMPv3 Configurations
-> Configure SNMPv3 Target Address Table. The Configure
SNMPv3 Target Address Table menu is shown in Figure 134.
Figure 134. Configure SNMPv3 Target Address Table Menu
Configure SNMPv3 Target Address Table
Converteon
Create SNMPv3 Table Entry
Delete SNMPv3 Table Entry
Modify SNMPv3 Table Entry
Display SNMPv3 Table Entry
Return to SNMPv3 Configurations ...