Allied Telesis AT-S102 - Manual (Page 191)

Converteon Management Software User’s Guide
191
Restoring the Default Settings
The procedures in this section are used to restore the default settings on
the AT-CM Line Cards. The default settings for the line cards can be found
in Chapter A, ”Default Settings for the Management Card and the Line
Cards” on page 337.
Caution
If the card’s current operating mode is not the default mode, the card
will reset, possibly resulting in the loss of some network traffic. The
line card will immediately resume forwarding traffic, but it will be
unresponsive to management commands for one minute while it
initializes its management software.
These procedures are not supported on the AT-CM70S Line Card or the
AT-CV Line Cards.
Menus
To restore the default parameter settings on a line card from the menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Status and Configuration menu shown in Figure 58
on page 158.
2. From the Module Status and Configuration menu, select the AT-CM
Line Card you want to return to the default settings. You can configure
only one line card at a time. The Module Configuration Menu in Figure
63 on page 169 is displayed.
3. Select Line Card Configuration to display the Line Card
Configuration Menu in Figure 72 on page 183.