Allied Telesis AT-S102 - Manual (Page 110)

Chapter 5: Configuring the AT-CV5M02 Management Card
110
Specifying the IP Addresses of the SNMP Trap Receivers
The management card can send SNMP traps to up to four trap receivers
on your network. The traps alert you to significant events in the operations
of the Converteon chassis, like the removal of line cards, the failure of a
cooling fan, or the loss of a link on a port on a media converter line card.
The requirements for this feature are described in “Accessing Your
Network” on page 31.
Menus
To specify the IP addresses of SNMP trap receivers from the menus:
1. From the Main Menu, select Configuration to display the
Configuration Menu shown in Figure 26 on page 100.
2. From the Configuration Menu, select System Configuration to
display the menu in Figure 27 on page 100.
3. From the System Configuration Menu, select System Parameters
Configuration to display the menu in Figure 28 on page 101.
4. Select IP Parameters to display the menu in Figure 29 on page 101.
5. In the Manager Address fields enter the IP addresses of the trap
receivers. To remove an IP address, enter 0.0.0.0.
6. To save your changes in the master configuration file, return to the
System Configuration Menu and select Save System
Configurations.
Web Browser
To specify the IP addresses of SNMP trap receivers from the web browser
windows:
1. Select Configuration from the left menu bar.
2. Select the SNMPv1 & SNMPv2c tab. The SNMPv1 & SNMPv2c tab is
shown in Figure 31 on page 107.
3. To change the addresses of the SNMP trap receivers, click the Edit
button to display a pop-up window.
4. In the Manager Address fields enter the IP addresses of up to four
trap receivers.
5. Click the Update button.
6. To save your changes in the master configuration file, refer to “Saving
Your Configuration Changes” on page 78.