Allied Telesis AT-S102 - Manual (Page 312)

Chapter 10: Configuring SNMPv3
312
Security Level [A-AuthNoPriv,
P-AuthPriv, N-NoauthNoPriv] The possible values are:
Note
This value must match the security level of the
corresponding user name in the SNMPv3 User Table.
A-AuthNoPriv
This option provides authentication, but no privacy protocol.
The SNMP user is authenticated, but without encryption. You
can select this value if you configured the Security Model
parameter with the SNMPv3 protocol.
P-AuthPriv
This option provides authentication and the privacy protocol.
This security level encrypts messages using a privacy protocol
and authenticate SNMP entities. This level provides the
greatest level of security. You can select this value if you
configured the Security Model parameter with the SNMPv3
protocol.
N-NoauthNoPriv
This option provides no authentication and no privacy protocol.
This security level is appropriate if you do not want
authentication of SNMP entities or encryption. This security
level provides the least security.
Note
The only security level for SNMPv1 and SNMPv2c is N-
NoauthNoPriv.
Storage Type [V-Volatile, N-
NonVolatile] The possible values are:
V-Volatile
This selection blocks the management card from saving the
entry in the master configuration file.
N-NonVolatile
This selection allows the management card to save the entry in
the master configuration file when a save command is issued.
Allied Telesis recommends this storage type.
Row Status This parameter appears only when you display the SNMPv3
Target Parameters Table. The Active value indicates the entry
takes effect immediately.
Table 39. SNMPv3 Target Parameters Table Parameters
Parameter Description