Allied Telesis AT-S102 - Manual (Page 254)

Chapter 9: Configuring the Operations, Administration, and Maintenance Client
254
Configuring the OAM Client
Menus
To configure the OAM clients on the line cards from the menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Configuration Menu shown in Figure 63 on page
169.
2. From the Module Status and Configuration Menu, select the AT-CM
Line Card you want to configure. This displays the Module
Configuration Menu shown in Figure 63 on page 169. You can
configure only one card at a time.
3. Select Port A, the fiber optic port, on the line card to display the Port
Management Menu shown in Figure 64 on page 170. The OAM client
is supported only on Port A.
4. From the Port Management Menu, select OAM Configurations to
display the OAM Configurations menu in Figure 105.
Figure 105. OAM Configurations Menu
Note
If the Port Management Menu doesn’t have the OAM Configurations
selection, the line card is not set to an OAM operating mode.
OAM Configurations
Module 4, Port A
OAM Configuration
Show Local OAM Information
Show Remote OAM Information
Show OAM Statistics
OAM Loopback Test
Send OAM Variable Request
Return to Port Management Menu ...