Allied Telesis AT-S102 User Manual
Page 251
Converteon Management Software User’s Guide
251
b. At the confirmation prompt, type Y and press Return to implement
the change or N and Return to cancel it.
5. To configure the settings of a T1/E1 port, enter the number of the
setting you want to change followed by the port (channel) number,
separated by a space. For example, to change the remote loopback
setting for port 2, you enter:
5 2
Table 30 on page 248 lists the possible settings.
6. When you finish managing the line card, simply disconnect the
management cable from the Console port. There is no logout
command. The card automatically updates its configuration file in flash
memory with your changes. If you remove the line card from the
chassis or power off the chassis, your changes are retained by the
card.