Allied Telesis AT-S102 - Manual (Page 195)

Converteon Management Software User’s Guide
195
Restoring the Last Saved Configurations to the AT-CM3 Line Cards
These procedures are used to restore the AT-CM301, AT-CM302, and
AT-CM3K0S Line Cards to their last saved configurations, stored on the
master configuration file on the management card. You might perform this
procedure to discard parameter changes you made to a line card but did
not save, or to configure a new line card with the save settings as the
previous card in the slot. For more information, refer to “Configuration
Files” on page 32.
This procedure is not supported on the AT-CM2, AT-CM70S or AT-CV
Line Cards.
Caution
If the card’s current operating mode is different from its last saved
configuration, the card will reset, possibly resulting in the loss of
some network traffic. As the line card initializes its management
software, which takes approximately one minute, it forwards traffic
using its default parameter settings.
Menus
To restore the last saved configuration to a line card from the menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Status and Configuration menu shown in Figure 58
on page 158.
2. From the Module Status and Configuration menu, select the AT-CM3
Line Card you want to configure. You can configure only one line card
at a time. The Module Configuration Menu in Figure 63 on page 169 is
displayed.
3. Select Line Card Configuration to display the menu in Figure 72 on
page 183.
4. To view the parameter settings of the card’s last saved configuration
before activating them on the line card, select Display Last Saved
Configuration. If the card is new to the slot, the settings are from the
previous card installed in the slot. If the fields are empty, the master
configuration file does not have a previous configuration for this slot or
the previous and current line cards of the slot are different models.
5. To return the line card to its last saved configuration, return to the Line
Card Configuration menu and select Restore Last Saved
Configuration.