Allied Telesis AT-S102 - Manual (Page 292)

Chapter 10: Configuring SNMPv3
292
Authentication Protocol
(continued) N-None
This value represents no authentication protocol. When
messages are received, users are not authenticated. This
selection does not support a Privacy Protocol.
Note
You may want to assign NONE to a super user.
Authentication Password An authentication password of 8 to 32 alphanumeric
characters. Applies only to MD5 and SHA authentication
protocols.
Privacy Protocol Applies only to MD5 and SHA authentication protocols. The
possible values are:
D-DES
This value makes the DES privacy (or encryption) protocol the
privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the device are
encrypted with the DES protocol.
N-None
Select this value if you do not want a privacy protocol for this
User Table entry. With this selection, messages transmitted
between the host and the switch are not encrypted.
Privacy Password A privacy password of 8 to 32 alphanumeric characters.
Applies only to DES privacy protocol.
Storage Type The possible values are:
V-Volatile
This selection blocks the management card from saving the
entry in the master configuration file.
N-NonVolatile
This selection allows the management card to save the entry in
the master configuration file when a save command is issued.
Allied Telesis recommends this storage type.
Row Status This parameter appears only when you display the SNMPv3
User Table. The Active value indicates the entry takes effect
immediately.
Table 33. SNMPv3 User Table Parameters
Parameter Description