Allied Telesis AT-S102 - Manual (Page 340)

Appendix A: Default Settings for the Management Card and the Line Cards
340
AT-CM2 and AT-CM70S Media Converter Line Cards
This table lists the factory default settings for the AT-S73 Management
Software on the AT-CM2 and AT-CM70S Media Converter Line Cards.
Table 46. Default Settings for the AT-CM2 and AT-CM70S Line Cards and
the AT-S73 Management Software
Parameter Default Setting
Default Operating Mode OAM Visible
Name None
Port A (Fiber Optic Port)
State Enabled
Flow Control Enabled
Ingress Rate Limit No Limit
Egress Rate Limit No Limit
Port B (Twisted Pair Port)
State Enabled
Flow Control Enabled
Speed and Duplex Mode Auto-Negotiation
Ingress Rate Limit No Limit
Egress Rate Limit No Limit
OAM
Admin State Enabled
Mode Passive
Maximum OAMPDU Size 1518 octets
Unidirectional Support Yes
Loopback Support Yes
Event Support No
Variable Retrieval Support Yes
T1/E1 Ports (AT-CM70S Line Card)
Carrier Type T1