Allied Telesis AT-S102 - Manual (Page 309)

Converteon Management Software User’s Guide
309
Configuring the SNMPv3 Target Parameters Table
This section describes the parameters for entries in the SNMPv3 Target
Parameters Table, which links the user security information with the
message notification information in the SNMPv3 Notify Table and the
SNMPv3 Target Address Table.
In the SNMPv3 Target Parameters Table, you specify the SNMP
parameters that are used when a message is generated to a target, or
host, IP address. The SNMPv3 Target Parameters Table also links a User
Name and its related security information, called user security information,
with a host. The user security information consists of the following
parameters listed in the SNMPv3 tables where they are configured:
ˆ User Name parameter configured in the SNMPv3 User Table menu
ˆ View Name parameter configured in the SNMPv3 View Table menu
ˆ Group Name, Security Model, and Security Level parameters
configured in the SNMPv3 Access Table
ˆ User Name, Security Model, and Group Name configured in the
SNMPv3 Group Table
When you enter user security information in an SNMPv3 Target
Parameters Table entry, the information must match the configuration in
the SNMPv3 tables listed above. If the user security information in the
SNMPv3 Target Parameters Table entry does not match the configuration
in the tables listed above, messages are not sent on behalf of the user.
Note
In the SNMPv3 Target Parameters Table, the Security Name
parameter is the equivalent to the User Name parameter in the
SNMPv3 User Table.
The parameters for the entries in the SNMPv3 Target Parameters Table
are:
ˆ Target Parameters Name
ˆ Security Name (User Name)
ˆ Security Model
ˆ Security Level
ˆ Storage Type