Displaying sfp module information, Menus – Allied Telesis AT-S102 User Manual
Page 213

Converteon Management Software User’s Guide
213
Displaying SFP Module Information
The procedures in this section are used to view the manufacturer’s
specifications for the SFP modules in the AT-CM2K0S, AT-CM70S and
AT-CM3K0S Line Cards. For SFP modules that support DDM in
AT-CM3K0S Line Cards, the windows are also used to display the alarm
thresholds that generate the event messages listed in Table 14 on
page 127.
Menus
To view the SFP information from the menus:
1. From the Main Menu, select Diagnostics. The Diagnostics Menu is
shown in Figure 53 on page 148.
2. Select Local CM Line Card Diagnostics to display the menu in
3. From the Diagnostics Menu, select SFP Information. The following
prompt is displayed:
Enter LineCard Slot Number: ->
4. Enter the slot number of the AT-CM2K0S, AT-CM70S or AT-CM3K0S
Line Card with the SFP module. The following prompt is displayed:
Enter LineCard Port [A or B]: ->
5. Enter the port of the SFP module.
The example of the SFP Information window shown in Figure 89 is
from the AT-CM3K0S Line Card. The Digital Diagnostics Monitoring
Information section, which lists the thresholds that generate the event
messages listed in Table 14 on page 127, is limited to SFP modules
that support digital diagnostics monitoring. Otherwise, that section of
the window is not displayed.