Allied Telesis AT-S102 - Manual (Page 138)

Chapter 5: Configuring the AT-CV5M02 Management Card
138
Restoring the Default Setting on the 10/100Base-TX Port
These procedures are used to restore the default setting of Auto-
Negotiation on the 10/100Base-TX port on the AT-CV5M02 Management
Card. Of course, you can achieve the same result by manually configuring
the port to Auto-Negotiation by performing either of the procedures in the
previous section. The procedures do not interrupt the network operations
of the media converter line cards in the chassis.
Note
The wiring configuration of MDI on the 10/100Base-TX port is not
adjustable.
Menus
To restore the default setting of Auto-Negotiation on the 10/100Base-TX
port from the menus:
1. From the Main Menu, select Module Status and Configuration.
2. Select the AT-CV5M02 Management Card in the menu to display the
Module Configuration Menu shown in Figure 35 on page 120.
3. Select Return Management Card Port Configuration to Default.
4. At the confirmation prompt select Yes to restore the default setting of
Auto-Negotiation on the port or No to cancel the procedure.
5. To save your changes in the master configuration file, return to the
Main Menu and select Configuration, System Configuration and
Save System Configuration.
Web Browser
To restore the default setting of Auto-Negotiation on the 10/100Base-TX
port from the web browser windows:
1. Select Module Status and Configuration from the menu bar.
2. In the Chassis View, click the 10/100Base-TX port on the AT-CV5M02
Management Card. Alternatively, select the Menu View tab and click
the name of the management card. The Port A tab for the
management card is shown in Figure 45 on page 136.
3. Select the General tab, shown in Figure 36 on page 121.
4. Click Return Management Card Port Configuration to Default
Setting.
5. At the confirmation prompt, click OK restore the default setting of Auto-
Negotiation on the 10/100Base-TX port or Cancel to cancel the
procedure.