Allied Telesis AT-S102 - Manual (Page 141)

Converteon Management Software User’s Guide
141
3. From the Configuration Menu, select System Configuration to display
the menu in Figure 27 on page 100.
4. Select Return System Configuration to Default. A confirmation
prompt is displayed.
5. At the confirmation prompt select Yes to restore the default setting on
the management card or No to cancel the procedure. If you respond
with yes, the management card resets and your management session
ends.
6. To resume managing the unit, wait one minute for the card to initialize
its management software and then start a local management session
on the card.
7. If you removed a standby AT-CV5M02 Management Card, reinstall the
card. The active card, whose parameter settings are now at their
default settings, waits for the standby card to initialize its management
software and then automatically sends its configuration file to it over
the backplane in the chassis, thus restoring the default values on the
standby card.
Web Browser
To restore the default settings on the management card from the web
browser windows:
1. If the chassis has two AT-CV5M02 Management Cards, remove the
standby card.
2. Click Configuration from the menus bar.
3. If the Systems tab is not displayed, select it. The system tab is shown
in Figure 30 on page 103.
4. Click the Edit button in the Configuration section of the window.
5. Click the radio button for Return System Configuration to Default
and click the Apply button.
The management card resets and your remote web browser
management session ends.
6. To resume managing the unit, wait one minute for the card to initialize
its management software and then start a local management session
on the card.
7. If you removed a standby AT-CV5M02 Management Card, reinstall the
card. The active card, whose parameter settings are now at their
default settings, waits for the standby card to initialize its management
software and then automatically sends its configuration file to it over
the backplane in the chassis, thus restoring the default values on the
standby card.