Allied Telesis AT-S102 - Manual (Page 233)

Converteon Management Software User’s Guide
233
4. Click the Default Configuration tab. This tab displays the default
settings for the line card. An example of the tab is shown in Figure 81
on page 193.
5. To return the card’s parameter settings to the default values, click the
Return to Default Configuration button. The parameter settings on
the card are returned to the default settings.
Restoring the
Last Saved
Configuration
This procedure is used to restore a remote line card to the last saved
configuration stored in the master configuration file on the management
card in the local chassis. This procedure can be useful if you want to
discard parameter changes that you may have made to a remote line card
but did not save in the master configuration file, or to configure a new line
card with the save settings as its predecessor. For more information, refer
to “Configuration Files” on page 32.
Caution
If the card’s current operating mode is different from its last saved
configuration, the card will reset, possibly resulting in the loss of
some network traffic. As the line card initializes its management
software, which takes approximately one minute, it forwards traffic
using its default parameter settings.
To use the web browser windows to restore the last saved configuration to
a remote line card:
1. From the Remote Module Status & Configuration window, select the
Line Card Configuration tab.
2. Select the Last Saved Configuration tab.
3. To return the line card to its last saved configuration, click the Restore
to Last Saved Configuration button.
Saving the
Parameter
Settings
When you change a parameter setting on a remote line card, the card
automatically saves your change in its configuration file in flash memory,
which retains your changes even when the chassis is powered off or the
card is removed from the enclosure.
The configuration settings of the remote line cards can also be saved in
the master configuration file on the management card, from where you can
restore them to the remote cards, should that ever be necessary. To
update the master configuration file on the management card, click the
Line Card Configuration tab, the Current Configuration tab, and the
Save Current Configuration button. To restore the setting to the line card
or to a replacement card, perform “Restoring the Last Saved
Configuration” on page 233.