beautypg.com

Saving the parameter settings, Resetting the remote at-cm3 line cards – Allied Telesis AT-S102 User Manual

Page 227

background image

Converteon Management Software User’s Guide

227

Saving the

Parameter

Settings

When you change a parameter setting on a remote line card, your change
is automatically saved by the card in its configuration file in flash memory,
which retains your changes even when the chassis is powered off or the
card is removed from the enclosure.

The configuration settings of the remote line cards can also be saved in
the master configuration file on the management card, from where they
can be restored to the remote cards, should that ever be necessary. To
update the master configuration file on the management card, select Line
Card Configuration
and Save Line Card Configuration. If you ever
need to restore the setting to the line card, perform “Restoring the Last
Saved Configuration” on page 226.

Resetting the

Remote AT-CM3

Line Cards

This procedure is not supported on the AT-CM2 and AT-CM70S Line
Cards.

Caution

This procedure will disrupt the network operations of the line card.
Some network traffic may be lost.

To reset a remote AT-CM3 Line Card:

1. From the Remote Module Configuration Menu, select Reset Line

Card. The line card immediately resets. No confirmation prompt is
displayed.

2. To continue managing the remote card, return to the Remote Module

Status and Configuration Menu and wait approximately one to two
minutes for the card to initialize its management software and
negotiate the OAM state with its local counterpart. Then select the card
again from the menu.

This manual is related to the following products: