Allied Telesis AT-S102 - Manual (Page 304)

Chapter 10: Configuring SNMPv3
304
Figure 133. SNMPv3 Notify Table Tab
The parameters for SNMPv3 Notify Table entries are defined in Table 37.
Table 37. SNMPv3 Notify Table Parameters
Parameter Description
Notify Name The name to be associated with this trap message. The name
can be up to 32 alphanumeric characters. For example, you
might define a trap message for hardware engineering and
enter a value of “hardwareengineeringtrap” for the Notify
Name.
Notify Tag The name of a Notify Tag. The name can be up to 32
alphanumeric characters. This parameter is added to the Tag
List parameter in the SNMPv3 Target Address Table, which
defines the IP addresses of the devices to receive the traps or
inform messages.
Notify Type The possible values are:
T-Trap
This option sends traps. SNMPv3 does not expect hosts to
respond to traps.
I-Inform
This option sends inform messages. SNMPv3 expects hosts to
respond to inform messages.
Storage Type The possible values are:
V-Volatile
This selection blocks the management card from saving the
entry in the master configuration file.