Allied Telesis AT-S102 - Manual (Page 198)

Chapter 6: Configuring the Media Converter Line Cards
198
Resetting an AT-CM3 Line Card
The procedures in this section explain how to reset individual AT-CM301,
AT-CM302, and AT-CM3K0S Line Cards in a Converteon chassis. You
might reset a line card if you believe it is experiencing a problem.
You cannot reset individual AT-CM2 and AT-CV Line Cards through the
management software. To reset one of these cards, you should remove it
from its enclosure, wait a few seconds, and then reinstall it.
Caution
Resetting an AT-CM3 Line Card disrupts its normal operations.
Some network traffic may be lost. When an AT-CM3 Line Card is
reset, it has to initialize its management software. During the
initialization process, which takes approximately one minute, the line
card forwards network traffic using the default values for its
parameter settings. Afterwards, it configures its parameters using
the settings from the AT-CV5M02 Management Card or from its own
configuration file, depending on the auto-copy setting of its slot.
For instructions on how to reset the AT-CV5M02 Management Card, refer
to “Resetting the Management Card” on page 119.
Menus
To reset an AT-CM3 Line Card from the menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Status and Configuration menu shown in Figure 58
on page 158.
2. From the Module Status and Configuration menu, select the AT-CM
Line Card you want to reset. The Module Configuration Menu in Figure
63 on page 169 is displayed.
3. Select Reset Line Card. There is no confirmation prompt. The line
card resets immediately.
Web Browser
To reset an AT-CM3 Line Card from the web browser windows:
1. Select Module Status & Configuration from the menu bar.
2. In the Chassis View, click either of the ports on the AT-CM3 Line Card
you want to reset. Alternatively, select the Menu View tab and click the
model name of the card. You can reset only one line card at a time.
3. Select the Setting tab.
4. Click the Reset Line Card button. There is no confirmation prompt.
The line card resets immediately.