Allied Telesis AT-S102 - Manual (Page 253)

253
Chapter 9
Configuring the Operations,
Administration, and Maintenance Client
The sections in this chapter are:
ˆ “Configuring the OAM Client” on page 254
ˆ “Performing the OAM Loopback Test” on page 259
ˆ “Displaying OAM Information on Local OAM Clients” on page 264
ˆ “Displaying OAM Information on Remote OAM Clients” on page 271
ˆ “Displaying OAM Statistics” on page 273
ˆ “Sending OAM Variable Requests to View MIB Variables” on page 275
Note
The AT-CM2, AT-CM70S, and AT-CM3 Line Cards have to be set to
an OAM operating mode before you can perform any of the
procedures in this chapter. Otherwise, the OAM menus and windows
are hidden from view. The appropriate mode for the AT-CM2 and
AT-CM70S Line Cards is OAM Visible. For the AT-CM3 Line Cards
the appropriate mode is any mode that supports OAM, such as Link
Test with OAM. For more information, refer to “Operating Modes” on
page 48 and “Setting the Operating Mode” on page 176.