beautypg.com

Starting a telnet management session – Allied Telesis AT-S102 User Manual

Page 75

background image

Converteon Management Software User’s Guide

75

Starting a Telnet Management Session

Note

The requirements for remote Telnet management are described in
“Accessing Your Network” on page 31.

The large windows in the management software require a Telnet client that
can support up to 125 characters per line.

To start a remote Telnet management session on the AT-CV5M02
Management Card:

1. Specify the IP address of the management card in the Telnet client at

your workstation. If the chassis has two management cards, enter the
IP address of the active card.

2. When prompted, enter the username and password of the manager or

operator account of the management card. The manager account has
the username “manager” and the default password “friend.” The
operator account has the username “operator” and the default
password “operator.” Usernames and passwords are case sensitive.

After you log on, the Main Menu in Figure 12 on page 73 is displayed.
For instructions on how to use the menus, refer to Table 10 on
page 74.

A Telnet management session gives you the same management
capability as a local management session. You can perform all of the
same management functions and configure all of the same line card
parameters.

3. To end a management session, select Quit from the Main Menu.

Note

You should always remember to select Quit from the Main Menu
when you are finished managing the chassis with the manager
account. If you close your terminal emulator program without logging
out, the management session remains active and the management
card rejects any further attempts to log on until the console timer has
timed out.

This manual is related to the following products: