Allied Telesis AT-S102 - Manual (Page 117)

Converteon Management Software User’s Guide
117
Configuring the Network Time Protocol Client
The AT-CV5M02 Management Card has an NTP client for setting the date
and time from a Network Time Protocol (NTP) server on your network or
the Internet. The date and time are added to event messages and SNMP
traps. Refer to “Accessing Your Network” on page 31 for the NTP client
requirements.
Menus
To configure the NTP client from the menus:
1. From the Main Menu, select Configuration. The Configuration menu
is shown in Figure 26 on page 100.
2. From the Configuration menu, select System Configuration.
3. From the System Configuration Menu, select System Parameters
Configuration to display the menu in Figure 28 on page 101.
4. From the System Configuration Menu, select System Clock
Configuration to display the menu in Figure 34 on page 115.
5. Select the NTP Server field and enter the IP address of the NTP
server.
6. Select the NTP UTC Offset field and enter the time difference, in
hours, between the Universal Time Coordinated (UTC) and your local
time. The range is between -12 and +12 hours. The default is 0 hours.
7. To enable the client, select Enable NTP.
8. To save your changes in the master configuration file, return to the
System Configuration Menu and select Save System Configurations.
Web Browser
To configure the NTP client from the web browser windows:
1. Select Configuration from the menu bar.
2. If the System tab is not selected, select it. The System tab is shown in
Figure 30 on page 103.
3. in the System Information section, click the Edit button.
4. Select the NTP Server field in the pop-up window and enter the IP
address of the NTP server.
5. Select the NTP UTC Offset field and enter the time difference, in
hours, between the Universal Time Coordinated (UTC) and your local
time. The range is between -12 and +12 hours. The default is 0 hours.