Allied Telesis AT-S102 - Manual (Page 127)

Converteon Management Software User’s Guide
127
The event messages listed in Table 14 are restricted to the
AT-CM3K0S Line Card and to SFP modules that support digital
diagnostic monitoring (DDM). The messages are grouped into Local
Messages and Remote Messages. Local messages are generated by
AT-CM3K0S Line Cards in the same chassis as the management card.
Remote messages are sent by remote line cards through remote peer
management.
For local messages the variable n identifies the slot of the AT-CM3K0S
Line Card that generated the message. For remote messages the
variable identifies in the local chassis the slot of the local line card that
received the message from the remote AT-CM3K0S Line Card.
The values that generate these messages on SFP modules are
vendor-specific and are not adjustable.
Power Module A/B
has been Removed AT-CV5000 Report The AT-PWR14 or AT-PWR15 Power
Supply Module was removed from the
AT-CV5000 Chassis.
Table 13. General Event Messages
Message Chassis
Classi-
fication
Definition
Table 14. SFP Module Event Messages
Message Classification Definition
Local Messages
SFP Insertion (local) in
linecard n Report An SPF module was installed in the
AT-CM3K0S Line Card.
SFP Removal (local) in
linecard n Report An SPF module was removed from the
AT-CM3K0S Line Card.
SFP Temp High|Low Alarm
(local) in linecard n Report The operating temperature of an SFP
module either exceeded the operating
range (High) or dropped below the range
(Low).
Clear The operating temperature of an SFP
module returned to the operating range.
SFP Vcc High|Low Alarm
(local) in linecard n Report The input voltage of an SFP module either
exceeded the operating range (High) or
dropped below the range (Low).
Clear The input voltage of an SFP module
returned to the operating range.